HP 3PAR StoreServ 7000 Service Manual page 55

24. Press ENTER to accept the default time indicated by the installation script or type the current
time in HH:MM format and press ENTER.
Basic Date and Time
Enter Control-C at any time to abort this process
Please enter the time in HH:MM format [<Time>]: [enter]
25. Typeyes and press ENTER to verify the indicated date in step 23.
Basic Date and Time
Enter Control-C at any time to abort this process
The date You entered is <current date>
Is this Correct? (yes or no)
yes
26. Select the default SSH site keys.
Using the DEFAULT, installed Site key files:
If this is the INITIAL INSTALLATION of this 3PAR SP
and InServ at this site, the DEFAULT keys should be used.
If this is a REPLACEMENT SP, or there is already an InServ
running at this site with which this SP must communicate,
do one of the following:
1) If you have external media containing the currently
deployed key pair (on CD or floppy), then answer NO
and provide the Keys to use.
2) If you do not have a copy of the current keys,
answer YES and force a key-exchange by MANUALLY
adding the cluster during the SP Moment of Birth,
or by using "spmaint" option 6.4.2 AFTER the moment
of birth to invoke (or force) a key exchange.
You may have to manually add any existing InServ
clusters in order to perform the key exchange.
Do you wish to use the DEFAULT, installed Site key files?
(y or n)
y
CAUTION: If you receive any Password: prompts during this process, the nodes in the
system have not been properly configured. Verify the IP addresses on the SP and controller
nodes. Use the red crossover cable to connect the highest node port ETH 0 to SP ETH 0 to
establish a private network.
27. Press ENTER to conclude Service Processor Setup Wizard configuration.
InServ configuration is no longer done during the Moment Of Birth.
Use spmaint after a successful MOB to do that configuration.
Manually Setting up the Service Processor 55