HP 3PAR StoreServ 7000 Service Manual page 43

You have two options for file transfer/remote operations:
1 ==> SP Mode where inbound/outbound access is via ssh session and control
is via the Customer Controlled Access (CCA) setting.
2 ==> Secure Network Mode where inbound/outbound access is via https and
is controlled by the 3PAR Secure Service Agent (SSAgent).
X None of the above. Cancel and Exit
Please enter your selection [X]:
2
5. Type 1 and press ENTER to continue with the new installation.
Type of install
Enter Control-C at any time to abort this process
How do you want to configure this SP?
1 ==>
2 ==>
X None of the above. Cancel and Exit
1
6. Type the domain name for the SSAgent and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the domain name for this SSAgent [?]:
Domain Name or <static.IP.address>
7. Press ENTER to accept the default SP name (in brackets) or type an alternate name and press
ENTER. The default SP name is the SP serial number. HP recommends accepting this default.
SP Network Parameters
Enter Control-C at any time to abort this process
Valid characters are [a-z] [A-Z] [0-9] dash(-) underscore(_)
Please enter the host name [SPXXXXX] :
[enter]
8. Type the static IP address assigned to the SP and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the IP address for the public network interface:
<static.IP.address>
Continue with spmob ( new site install )
Restore from a backup file ( SP rebuild/replacement )
Manually Setting up the Service Processor 43