HP 3PAR StoreServ 7000 Service Manual page 58

8. Press ENTER to accept the default subnet mask or type an alternate subnet mask for the SP
and press ENTER.
Please enter the netmask for this interface [255.255.255.0]:
<subnet.mask.address>
9. Press ENTER to accept the default gateway address shown in brackets, or type a default
gateway address and press ENTER. The setup script suggests a default gateway address based
on the IP address you have supplied.
Please enter the IP address of a default gateway, or NONE [<static.IP.address.1>]:
<default.gateway.address>
10. Press ENTER to indicate the Ethernet interface is used for file transfers.
Will this ethernet interface be used for inbound and/or
outbound file transfers (yes or no)? [no]
1 1. Type no to indicate the SP shall not be remotely controlled.
SP Network Parameters
Portal)
no
12. Press ENTER or type no if the SP shall use the 3PAR Connection Portal.
SP Network Parameters
Will this SP use the 3PAR Connection Portal? ( yes or no ) [no]
13. Answer the prompts about your proxy system.
SP Network Parameters
Does the connection to the CP require proxy services? (yes or no) [no]
no
Please enter the name of the proxy system
<proxy.system.name>
<proxy.system.address>
58 Installing Storage Software Manually
Enter Control-C at any time to abort this process
Will this SP be allowed to be remotely controlled(yes or no)? [yes]
(Replying 'yes' will allow Remote Operations sessions from a Connection
Enter Control-C at any time to abort this process
Enter Control-C at any time to abort this process
-OR-
quit to abort setting a proxy
Please enter the IP address of the proxy system
-OR-
quit to abort setting a proxy
Please enter the protocol supported by the proxy system from the list
HTTP