Thermistor Input (X4:8 - ABB ACSM1 Hardware Manual

60

Thermistor input (X4:8...9)

Motor temperature can be measured using PTC or KTY84 sensors connected to the
thermistor input.
One PTC or KTY84 sensor
Motor
T
WARNING! As the thermistor input on the JCU Control Unit is not insulated
according to IEC 60664, the connection of the motor temperature sensor requires
double or reinforced insulation between motor live parts and the sensor. If the
assembly does not fulfil the requirement,
• the I/O board terminals must be protected against contact and must not be
connected to other equipment
or
• the temperature sensor must be isolated from the I/O terminals.
Electrical installation
TH
AGND
10 nF
Three PTC sensors
Motor
T T
T
TH
AGND
10 nF