Table of Contents
Advertisement
®
ABB i-bus
EIB / KNX
8
Device technology
Supplied state
Analogue Input is supplied with the physical address 15.15.255.
The Threshold value measurement/1 application program is preloaded.
It is therefore only necessary to load parameters and group addresses
during commissioning. However the complete application program can be
reloaded if required.
Download behaviour
Due to the complexity of the device, it can take up to 1.5 min. during a
download until the progress bar appears, depending on the computer used.
Assignment of the physical address
The physical address, group address and parameters are assigned and
programmed in the ETS software.
Cleaning
Dirty devices can be cleaned using a dry cloth. If this is not sufficient, a cloth
that has been dampened slightly with a soap solution can be used. Caustic
agents or solvents may not be used under any circumstances.
Maintenance
The device is maintenance-free. In the event of damage (e.g. caused during
transportation or storage), no repairs may be carried out by external staff.
When the device is opened, the right to claim under guarantee expires.
The maintenance schedule for the sensors must be requested from the
sensor manufacturers.
Advertisement
Table of Contents
