Commissioning Via Hmi; Wizard Introduction - Siemens SITRANS FC430 Operating Instructions Manual

Commissioning

6.3 Commissioning via HMI

Commissioning and operation with pending error
If an error message appears, correct operation in the process is no longer guaranteed.
• Check the gravity of the error.
• Correct the error.
• If the error still exists:
6.3 Commissioning via HMI
6.3.1

Wizard introduction

In this chapter it is described how to commission the device via the local display (HMI) using
the Quick Commissioning wizard.
For further information on how to navigate the wizards, refer to Wizards (Page 78).
In the wizard graphics below, the HMI view numbers are stated to the left.
The first view in each wizard (About - view 1) is a description of what settings/actions can be
performed using the specific wizard.
The last view in each wizard (Finished) shows that the last step of the wizard was
completed.
Any parameter changes confirmed with
At any time in any wizard selecting Exit will bring you back to the main wizard menu without
discarding changes.
The first time the device is powered up, you will be prompted to set the language. The device
always starts up showing Language in English. When the language has been set, you will be
prompted to set the date and time.
After confirming/changing the date and time you will be asked if you want to start the Quick
Commissioning wizard. If you choose Yes (recommended), the Quick Commissioning wizard
will start. If you choose No, you accept the default values of the device, and the next HMI
view will be the operation view 1.
74
WARNING
– Take the device out of operation.
– Prevent renewed commissioning.
are saved immediately.
Operating Instructions, 05/2015, A5E03361511-AF
FC430 with HART