Safe Operation; C.7 Safe Operation - Siemens SITRANS FC430 Operating Instructions Manual

Default settings

C.7 Safe Operation

C.7

Safe Operation

Table C- 27 Safe Operation
HMI menu ID Parameter
2.7.1 Safety Mode
2.7.2 Enter Safe Configura-
tion
2.7.3 Start Safety Validation
2.7.4 Safety Validation
2.7.4 Low Flow Cut-Off
2.7.4 Filter Time Constant
2.7.4 Upper Scaling
2.7.4 Lower Scaling
2.7.4 Direction
2.7.4 Flow Direction
2.7.4 Massflow Adjust.Factor
2.7.4 Density Adjust. Factor
2.7.4 Density Adjust. Offset
2.7.4 Process Noise Damping Validate parameter {refer to
2.7.6 Modify Safe Configura-
tion
2.7.7 Enter Non-Safe Opera-
tion
2.7.8 Acknowledge Safety
Alarms
330
Description
Operation mode for safety criti-
cal applications.
Setup parameters {refer to
Safety Manual}. Safe output is
fixed at 3.6 mA
Validate listed "Safety Parame-
ters" according to operating
values {refer to Safety Manual}.
Validate listed "Safety Parame-
ters" according to operating
values {refer Safety Manual}.
Safe output is fixed at 3.6 mA.
Validate parameter {refer to
Safety Manual}
Validate parameter {refer to
Safety Manual}
Validate parameter {refer to
Safety Manual}
Validate parameter {refer to
Safety Manual}
Validate parameter {refer to
Safety Manual}
Validate parameter {refer to
Safety Manual}
Validate parameter {refer to
Safety Manual}
Validate parameter {refer to
Safety Manual}
Validate parameter {refer to
Safety Manual}
Safety Manual}
Modify parameters {refer Safety
Manual}. Safe output is fixed at
3.6 mA
Start None-Safe Operation.
Output 4-20 mA reflects select-
ed process value
Check process conditions,
acknowledge alarms to return to
safe operation
Default value Value range
[unit]
Non-Safe Oper-
ation
Operating Instructions, 05/2015, A5E03361511-AF
Access level
Read only
User
User
User
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
User
User
User
FC430 with HART