Process Values; C.2 Process Values - Siemens SITRANS FC430 Operating Instructions Manual

Default settings

C.2 Process Values

C.2

Process Values

Table C- 2 Massflow
HMI menu ID Parameter
2.2.1.1 Unit
2.2.1.2 Low Flow Cut-Off
2.2.1.3 Upper Limit Alarm
2.2.1.4 Upper Limit Warning
2.2.1.5 Lower Limit Warning
2.2.1.6 Lower Limit Alarm
2.2.1.7 Alarm Hysteresis
2.2.1.8 Decimal Places
: See Sensor dimension dependent default settings (Page 373)
1)
260
Description
Select unit for displayed mass
flow rate. Unit is not applied at
communication interface.
Set massflow limit for low flow
cut-off. Below limit massflow
output is forced to zero.
Set upper limit alarm. Alarm is
displayed if massflow value is
above the limit.
Set upper limit warning. Warn-
ing is displayed if massflow
value is above the limit.
Set lower limit warning. Warn-
ing is displayed if massflow
value is below the limit.
Set lower limit alarm. Alarm is
displayed if massflow value is
below the limit.
Enter the hysteresis to avoid
unwanted rapid switching.
Define the decimal point for the
process value displayed in the
Local User Interface.
Default value Value range
[unit]
kg/s g/s, g/min,
g/h, kg/s,
kg/min, kg/h,
kg/d, t/min,
t/h, t/d, lb/s,
lb/min, lb/h,
lb/d,
STon/min,
STon/h,
STon/d, T/h,
T/d
1) 1)
1) 1)
1) 1)
1) 1)
1) 1)
1) 1)
2
0
•
1
•
2
•
3
•
4
•
5
•
6
•
Operating Instructions, 05/2015, A5E03361511-AF
Access level
User
User
User
User
User
User
User
User
FC430 with HART