Mitsubishi Electric MELSEC iQ-R Series User Manual page 161

No. Name Description
SW0009 Monitoring time Sets monitoring time when dedicated instructions are used.
setting Default: 10 (seconds) (value = 0)
Setting range: 1 to 360 (seconds)
If a value outside the range is set, the monitoring time will be 360 seconds.
When SW000B is set, the time until a dedicated instruction fails is as follows:
(Number of retries + 1)  monitoring time
SW000A CPU monitoring Sets the monitoring time of CPU response when the CPU module is accessed
time setting through transient transmission.
Default: 90 (seconds) (value = 0)
Setting range: 1 to 3600 (seconds)
If a value outside the range is set, the monitoring time will be 3600 seconds.
SW000B Dedicated Sets the number of retries of when dedicated instructions are used.
instruction retry Default: 0 (No retry)
count setting Setting range: 0 to 7 (time)
If a value outside the range is set, the number of times will be 7.
SW0014 Specification of Specifies a station where an initial processing is performed using the information
to remote device registered by the initialization procedure registration using an engineering tool.
SW0017 station to be 0: Initial processing not performed
initialized 1: Initial processing performed
SW0014
SW0015
SW0016
SW0017
The stations need not be set by the number of occupied stations.
Error invalid stations, reserved stations, station with the end station number, and
stations later than that are excepted.
SW0020 Module status Stores the communication status between the master/local module and CPU
module.
0: Normal
Values other than 0:Error code ( User's manual for the CPU module used)
SW0041 Data link restart Stores whether the data link restart instruction using SB0000 has been normally
result completed.
0: Normal
Values other than 0:Error code ( Page 123 List of Error Codes)
SW0043 Refresh Stores whether the refresh instruction at standby master switching has been
instruction at normally completed.
standby master 0: Normal
switching result Values other than 0:Error code ( Page 123 List of Error Codes)
SW0045 Data link stop Stores whether the data link stop instruction using SB0002 has been normally
result completed.
0: Normal
Values other than 0:Error code ( Page 123 List of Error Codes)
SW0049 Temporary error Stores whether the temporary error invalid station specification has been
invalid station normally completed.
specification 0: Normal
result Values other than 0:Error code ( Page 123 List of Error Codes)
SW004B Temporary error Stores whether the temporary error invalid station setting has been normally
invalid station canceled.
specification 0: Normal
cancel result Values other than 0:Error code ( Page 123 List of Error Codes)
SW004D Line test result Stores the result of a line test.
0: Normal
Values other than 0:Error code ( Page 123 List of Error Codes)
SW0057 Master station Stores whether a master station duplication error cancel request has been
duplication error normally completed.
cancel result 0: Normal completion
Values other than 0:Error code ( Page 123 List of Error Codes)
to
b15 b14 b13 b12
16 15 14 13 to
32 31 30 29 to
48 47 46 45 to
64 63 62 61 to
1 to 64 in the table indicate station numbers.
Availability (: Available, : Not
available)
Online
Master
station




b3 b2 b1 b0
4 3 2 1
20 19 18 17
36 35 34 33
52 51 50 49








Appendix 5 List of Link Special Register (SW) Areas
Offline
Local
station
 
 
 
 
 
 
 
 
 
 
 
 
APPX
159
A