Mitsubishi Electric CR750-D Instruction Manual page 105

■ Input the described program into the controller.
The T/B is used for this operation.
Preparing the T/B
MODE
MANUAL AUTOMATIC
Rear of T/B
<MENU>
1.FILE/EDIT
3.PARAM.
5.SET/INIT.
123
<FILE/EDIT>
1 08-04-24 17:20:32
2 08-04-24 14:56:08
A1 08-04-24 13:05:54
B1 08-04-24 13:05:54
123
EDIT POSI.
<NEW PROGRAM>
PROGRAM NAME
( 1_
ABC
<PROGRAM> 1
DELETE 123
EDIT
◇◆◇ Using the T/B ◇◆◇
Set the controller mode to "MANUAL" and the T/B [ENABLE] switch to "ENABLE". Operations from the T/B
are not possible unless the controller mode is set to "MANUAL".
◇◆◇ Inputting numbers ◇◆◇
Each time the [CHARACTER] key is pressed, the number input mode and the character input mode change.
The current input mode is displayed in the center under the screen, and the display of "123" shows that the
number input mode. The number currently written to the lower left of each key in this state can be inputted.
◇◆◇ Correcting incorrect numbers ◇◆◇
Press the [CLREAR] key to delete the character, and then input it again. And, if the long pushing [CLEAR] key,
all the data in the parenthesis can be deleted.
If the cursor is returned by pressing the [ ← ] key, and a character is input, it will be inserted.
Up ：DISABLE
Down：ENABLE
*Lighting
2.RUN
4.ORIGIN/BRK
6.ENHANCED
CLOSE
1/20 Rem 136320
22490
694
2208
1851
NEW ⇒
COPY
)
CLOSE
100%
⇒
INSERT TEACH
1) Set the controller mode to "MANUAL".
2) Set the T/B [ENABLE] switch to "ENABLE".
3) In the <MENU> screen, press the arrow keys
(" ↑ ", " ↓ ", " ← ", " → ") and move the
cursor to "1. Management and edit", and
then press the [EXE] key. The <Management
～
and edit> screen will appear.
4) Press the [F3](New) key, and display the new
program screen.
5) Press [1], [EXE] key, and display the edit
screen of program No1.
4Basic operations
Programming 4-93