Self Diagnostic; Before Operating - Blomberg KSE 1550 i User Manual

GB
High freezer temperature warning light
(RED) (6)
If the freezer temperature becomes too high,
then the warning indicator light (6) will flash.
If the red indicator (6) remains on more than
12 hours, please contact with your service
agency.
Don't worry if the red indicator light comes on
briefly. It could be due to warm food storage
or warm air in the freezer compartment or if
the freezer door has been left open for long
periods.
Fast freeze function:
The fast freeze function enables you to load
fresh food to be frozen.
When you press fast freeze button (1), the
orange indicator light (4) will go on and the
compressor will run for about 24 hours.
To cancel, press fast freeze button again and
the orange light will go out.
Fast freeze will cancel itself automatically after
24 hours, if you do not cancel it manually.
The electronic control system incorporates a
safety protection device so that if the fast
freeze button (1) is pressed more than once,
the compressor will not come on. Wait for
about 10 minutes and try again.

Self diagnostic:

Your appliance incorporates a self-diagnostic
system. Certain characters (E0, E1, etc.) will
be displayed where the freezer temperature
is usually shown. During this time red light (6)
will flash. Please first see "trouble shooting"
section and then "Service" section for further
information.

Before operating

Final Check
Before you start using the appliance check
that:
1. The interior is dry and air can circulate freely
at the rear.
2. The interior is clean as recommended under
"Cleaning and care."
3. The plug has been inserted into the wall
socket and the electricity is switched on. When
the door is open the interior light will come on.
And note that:
4. You will hear a noise as the compressor
starts up. The liquid and gases sealed within
the refrigeration system may also make some
(noise), whether the compressor is running or
not. This is quite normal.
5. Slight undulation of the top of the cabinet
is quite normal due to the manufacturing
process used; it is not a defect.
6. Do not load the appliance immediately it is
switched on. Wait until the correct storage
temperature has been reached. We
recommend checking the temperature with an
accurate thermometer (see; Temperature
Control and Adjustment).
7. If the appliance is not going to be used for
a long period of time, switch it off from the
switch on the thermostat box, remove all food,
clean it and leave the door ajar. (Fig.1-3)
5
Instruction Manual