ABB SM1000 User Manual page 41

...4.1.2 Configuration Level Access – Figs. 4.1 and 4.2
Note. The Internal Security Switch is used to access the Configuration level when 'Configuration security' is set to
'Switch protected' – see Section 4.4.2.
security' is set to 'Password protected' (default setting) unless the Password has been forgotten. The switch
overrides Password protection, enabling free access to the Configuration level.
Switch off the power to
the instrument and unscrew
2 the jacking screw securing
the instrument to the case.
Remove tamper-proof
1
seal (if fitted)
use the switch to access the Configuration level when 'Configuration
Do Not
Withdraw the instrument
3
from the case
Note. The red switch is for factory use only. Ensure that it
remains in the position closest to the rear of the instrument.
Fig. 4.2 Setting the Security Switch
Set the yellow Security switch to the
4
'Configuration Level Not Protected' position
Configuration Level Protected
Configuration Level Not Protected
Red Switch
(see
Note
Refit the instrument to the case
5
and secure with the jacking screw
Re-apply power to the
6
instrument and wait for
the Operator Level to display
Access the Configuration level
7
as shown in Fig. 4.1
4 CONFIGURATION...
below)
39