COMMANDS MENU
7.1.1 Virtual inputs
COMMANDS VIRTUAL INPUTS
COMMANDS
VIRTUAL INPUTS
The states of up to 64 virtual inputs are changed here. The first line of the display indicates the ID of the virtual input. The
second line indicates the current or selected status of the virtual input. This status is a state off (logic 0) or on (logic 1).
7.1.2 Clear records
COMMANDS CLEAR RECORDS
COMMANDS
CLEAR RECORDS
7
This menu contains commands for clearing historical data such as the event records. Data is cleared by changing a
command setting to "Yes" and pressing the
"No."
7.1.3 Set date and time
COMMANDS SET DATE AND TIME
COMMANDS
SET DATE AND TIME
7-2
Virt Ip 1
Off
Virt Ip 2
Off
Virt Ip 64
Off
CLEAR USER FAULT
REPORTS? No
CLEAR EVENT RECORDS?
No
CLEAR OSCILLOGRAPHY?
No
CLEAR DATA LOGGER?
No
CLEAR ENERGY?
No
CLEAR UNAUTHORIZED
ACCESS? No
CLEAR MOTOR START
DATA? No
CLEAR BROKEN ROTOR
BAR DATA? No
CLEAR DIRECT I/O
COUNTERS? No
CLEAR TELEPROTECT
COUNTERS? No
CLEAR ALL RELAY
RECORDS? No
key. After clearing data, the command setting automatically reverts to
ENTER
SET DATE AND TIME:
2000/01/14 13:47:03
CHAPTER 7: COMMANDS AND TARGETS
Range: Off, On
Range: Off, On
Range: Off, On
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes.
Valid only for units with Direct Input/Output module.
Range: No, Yes
Range: No, Yes
Range: YYYY/MM/DD HH:MM:SS
M60 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL