Setting Groups - GE M60 Instruction Manual

CONTROL ELEMENTS
SETTINGS
TRIP BUS 1 INPUT 1
TRIP BUS 1 INPUT 2
TRIP BUS 1 INPUT 16
SETTINGS
TRIP BUS 1
FUNCTION
TRIP BUS 1 BLOCK
SETTINGS
TRIP BUS 1
LATCHING
TRIP BUS 1 RESET
FLEXLOGIC OPERAND
RESET OP

5.8.3 Setting groups

5
SETTINGS  CONTROL ELEMENTS  SETTING GROUPS
 SETTING GROUPS

The setting groups menu controls the activation and deactivation of up to six possible groups of settings in the
settings menu. The active setting group can be indicated on the front display of the UR by configuring User-
ELEMENTS
Programmable LEDs to display the state of the
SETTING GROUPS FUNCTION
activated. The default setting group is forced active while the
SETTING GROUPS BLK —
can be useful in applications where it is undesirable to change the settings under certain conditions, such as during a
control sequence.
5-232
Figure 5-129: Trip bus logic
= Off
= Off
OR
AND
= Off
= Enabled
AND
= Off
= Enabled
= Off
OR
SETTING GROUPS

FUNCTION: Enabled
SETTING GROUPS BLK:

Off
GROUP 2 ACTIVATE ON:

Off
GROUP 6 ACTIVATE ON:

Off
GROUP 1 NAME:

GROUP 6 NAME:

SETTING GROUP

EVENTS: Disabled
SETTING GROUP ACT
— When Enabled, allows setting groups other than group 1 (the default active group) to be
Prevents the active setting group from changing when the selected FlexLogic operand is "On." This
SETTINGS
TRIP BUS 1 PICKUP
DELAY
Non-volatile,
TRIP BUS 1 RESET
set-dominant
DELAY
S
T
PKP
Latch
R
Range: Disabled, Enabled
Range: FlexLogic operand
Range: FlexLogic operand

Range: FlexLogic operand
Range: up to 16 alphanumeric characters

Range: up to 16 alphanumeric characters
Range: Disabled, Enabled
FlexLogic operands.
SETTING GROUPS FUNCTION
M60 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
FLEXLOGIC OPERAND
TRIP BUS 1 OP
T
RST
FLEXLOGIC OPERAND
TRIP BUS 1 PKP
842023A1.CDR
GROUPED
setting is Disabled.