Connecting Cables - Huawei SmartLogger2000 User Manual

SmartLogger2000
User Manual
About This Chapter
Context


4.1 Connection Description
4.2 Connecting the PE Cable
The SmartLogger and SPD are separately connected to the ground bar for grounding
protection through a PE cable.
4.3 Connecting the RS485 signal SPD
4.4 Connecting Inverters
4.5 Connecting an EMI
4.6 Connecting a Power Meter
4.7 Connecting the Box-type Transformer
4.8 Connecting a PID Module
4.9 Connecting a Ripple Control Receiver
(2016-06-20)
This section describes how to connect the SmartLogger to inverters and other devices in the scenario

without a smart array controller.
For a smart array controller, the SmartLogger and RS485 signal SPDs are installed before delivery.

For devices using the RS485 communications mode, connect the RS485 communications cable to
the X2 terminal block on the smart array controller. For devices using the PLC mode, connect the
AC power cable to the X1 terminal block on the smart array controller. For details about the two
connection methods, see SmartACU2000-C Smart Array Controller User Manual.
Ensure that all cables are connected securely.
The SmartLogger has no start key. Before the cable connections for the SmartLogger are
complete, do not connect a power adapter to it.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4

Connecting Cables

4 Connecting Cables
36