Connecting Optical Fibers - Huawei SmartLogger2000 User Manual

SmartLogger2000
User Manual
----End
Follow-up Procedure
Disconnection can be performed in reverse order.

4.11 Connecting Optical Fibers

Context
The SmartLogger can be connected to devices such as an ATB through optical fibers. You can
select the devices to be connected based on the actual networking scenario. For the typical
application scenarios, see Figure 2-6 and Figure 2-7 in 2.4 Typical Networking Scenarios.
Procedure
Step 1 Insert the optical module into the SFP1 or SFP2 port on the SmartLogger.
Step 2 Connect the two optical fibers delivered with the optical module to the ports on the optical
module.
Step 3 Connect the other end of the optical fiber to the ATB, as shown in Figure 4-35.
(2016-06-20)
If the SmartLogger is connected to a PC directly or through a hub, the IP addresses of the

SmartLogger and PC must be in the same network segment. For example, if the IP address of the
SmartLogger is 192.168.0.10, the IP address of the PC can be 192.168.0.11. The subnet mask and
the gateway of the PC should be consistent with those of the SmartLogger.
If the SmartLogger is connected to a PC through a networking device (such as a router), the IP

addresses of the SmartLogger and networking device must be in the same network segment. Set the
gateway of the SmartLogger correctly so that it can communicate with the networking device.
To enable communication between the SmartLogger and the NetEco, set the NetEco parameters

properly on the SmartLogger. For details, see Setting NetEco Parameters.
An optical module is optional. An optical module with a transmission speed of 100 Mbps and an

optical fiber length within 12 km is recommended.
When inserting an optical module into the SFP1 port, verify that the side with a handle faces

upwards. When inserting an optical module into the SFP2 port, verify that the side with a handle
faces downwards.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Cables
66