ABB SM2000 User Manual page 49

Advanced Videographic Recorder
SM2000
Note. The Internal Security Switch is used to access the Configuration level when 'Configuration security type' is set to 'Internal
switch protected' – see Section 4.4.4, page 56.
security type' is set to 'Password protected' (default setting) unless the Password has been forgotten. The switch overrides
Password protection, enabling free access to the Configuration level.
Switch off the power to
the instrument and unscrew
2
the jacking screw securing
the instrument to the case.
Remove tamper-proof
1
seal (if fitted)
Fig. 4.2 Setting the Security Switch
Note. The red switch is for factory use only. Ensure it remains in the position closest to the rear of the instrument.
IM/SM2000 Issue 11
use the switch to access the Configuration level when 'Configuration
Do Not
Withdraw the instrument
3
from the case
Set the yellow Security switch to the
4
'Configuration Level Not Protected' position
Configuration Level Protected
Configuration Level Not Protected
Red Switch
(see
Note
Refit the instrument to the case
5
and secure with the jacking screw
Re-apply power to the
6
instrument and wait for
the Operator Level to display
7 Access the Configuration
Level as shown in Fig. 4.1
4 CONFIGURATION
below)
47