(3) Installing Firmware and PLD Code
1)
Purpose
Write exposure code and PLD code into the Flash ROM of the 50Di PCB in the imaging
unit.
2)
Notes
Be sure to check that the CXDI is connected to the system.
3)
Procedure
3-1) Installing the firmware
Write the firmware by referring to "Firm Write Tool Software (Firmwrite.exe)" in the Tool
Software Operation Manual for CXDI-50G.
Where to write: IC1 (Flash ROM) on 50Di PCB
3-2) Installing PLD code
Write PLD code by referring to "PLD Write Tool Software (pldwrite.exe)" in the Tool
Software Operation Manual for CXDI-50G.
Where to write: IC10 (Flash ROM) on 50Di PCG
2. Installation Manual
- 32 -