ABB i-bus KNX Product Manual page 31


ABB i-bus KNX
Device technology
The reaction of the operating elements is described in the following table, according to the operating
states, KNX operation and Manual operation:
Button
Manual operation
Groups
Detect devices
ON/Dim UP
OFF/Dim DOWN
KNX operation
Long button operation (about 3 sec.): Switch to manual
operation, provided that manual operation is not blocked
by a parameter setting.
Short button operation: LED Manual operation flashes
and switches off again. DLR/S continues in KNX mode.
When manual mode is achieved, the first lighting group
is automatically selected, but not yet controlled. The LED
lights up.
No reaction
No reaction
No reaction
No reaction
Manual operation
Long button operation (about 3 sec.): Changeover to KNX
operation. The brightness values of the lighting groups
initially remain unchanged. The functions are updated only
after receipt of new values on the corresponding
communication objects.
KNX telegrams are ignored in manual operation and also
not subsequently implemented.
Resetting of manual operation in KNX operation occurs
after the last operation within the parameterized time
10...300...6000 s.
Short button operation: Lighting groups can be selected
successively. The exited lighting group retains its current
brightness value. The state of the newly selected lighting
group remains unchanged (group function).
Long button operation: All the lighting groups are selected
together. The brightness of the lighting groups remains
unchanged (broadcast function).
Long button operation (> 5 Sec.): LED
The connected ballasts are detected and marked as
monitored.
Short button operation: The selected lighting group(s)
is/are switched on.
Long button operation: Relative dimming up of the
selected lighting group(s) when the button is pressed.
The switch-on or dimming reaction corresponds with the
parameterized values as set in the ETS or that have been
changed via KNX.
Short button operation: The selected lighting group(s)
is/are switched off.
Long button operation: Relative dimming down of the
selected lighting group(s) when the button is pressed.
The switch-off or dimming reaction corresponds with the
parameterized values as set in the ETS or that have been
changed via KNX.
DLR/S 8.16.1M | 2CDC 507 100 D0202 29
flashes.