Dlr/S 8.16.1M; Technical Data Dlr/S 8.16.1M - ABB i-bus KNX Product Manual


ABB i-bus KNX
Device technology
2.1

DLR/S 8.16.1M

2.1.1

Technical data DLR/S 8.16.1M

Supply
DALI output
Sensor inputs
Connections
Brightness detection
12 2CDC 507 100 D0202 | DLR/S 8.16.1M
Light controller supply voltage
Power consumption total via mains
Current consumption total via mains
Leakage loss total for device
Current consumption KNX
Power consumption via KNX
Number of outputs
Number of DALI devices
Number of lighting groups
Distance between DLR/S and last DALI device
Cable cross-section 0.50 mm
0.75 mm
1.00 mm
1.50 mm
Light Sensor LF/U 2.1
Number of inputs
Max. cable length per sensor
KNX
DALI outputs and mains voltage
Tightening torque
Light Sensor LF/U:
Wire end ferrule without/with plastic sleeve
TWIN ferrule
Tightening torque
Lighting control operating range
85...265 V AC, 50/60 Hz
110...240 V DC
Maximum 3.5 W at 230 V AC and max. load
Maximum 15 mA at 230 V AC and max. load
Maximum 1.6 W at 230 V AC and max. load
Maximum 10 mA
Maximum 210 mW
1 to EN 60 929 and DIN EN 62 386
The DALI output is a fixed 230 V, i.e.
unintentional application of the light controller
supply voltage will not cause destruction of the
DALI output.
Maximum 64
16
2)
100 m
2
2)
150 m
2
2)
200 m
2
2)
300 m
2
For detailed information,
see Light Sensor LF/U
8
Per light sensor 100 m, Ø 0.8 mm,
P-YCYM or J-Y(ST)Y cable (SELV),
e.g. shielded KNX bus cable
KNX connection terminal,
0.8 mm Ø, solid
Screw terminal:
0.2...2.5 m
m2
fine stranded
0.2...4 mm
2
Max. 0.6 Nm
Without 0.25...2.5 mm
0.5...2.5 mm
2
Max. 0.6 Nm
Optimized for 500 Lux.
200...1,200 Lux for rooms with average
furnishing level, degree of reflection 0.5
Max. 860 Lux in a very brightly furnished room
(reflection 0.7)
Max. 3,000 Lux in a very darkly furnished room
(reflection 0.2)
The Lux values are measured values on the
work surface (reference surface)
1)
1)
1)
2.1, page 18
single core
/ with 0.25...4 mm
2 2
3)
.