HP 10500 Series Configuration Manual page 67

Figure 21 Adding an IP address group
# Add a portal device.
Select User Access Manager > Portal Service Management > Device from the navigation tree to
enter the portal device configuration page. Then, click Add to configure a portal device as follows:
a. Enter the device name NAS.
b. Enter the IP address of the access interface on the device, which is 192.168.1.70.
c. Enter the key, which is portal, the same as that configured on the switch.
d. Specify whether to enable IP address reallocation. Because direct portal authentication is used
in this example, select No from the Reallocate IP list.
e. Click OK.
Figure 22 Adding a portal device
# Associate the portal device with the IP address group.
As shown in Figure
the Port Group Information Management column of device NAS to enter the port group
configuration page.
23, in the device list on the portal device configuration page, click the icon in
57