HP 10500 Series Configuration Manual page 66

3. Configure the portal server (when the server runs on IMC PLAT 5.0):
NOTE:
This section assumes that the RADIUS server runs on IMC PLAT 5.0 (E0101H03) and IMC UAM 5.0 SP1
(E0101P03).
# Configure the portal server.
Log in to IMC and click the Service tab. Then, select User Access Manager > Portal Service
Management > Server from the navigation tree to configure the portal server as follows:
a. Enter the URL address of the portal authentication main page, in the format
http://ip:port/portal, where ip and port are those configured during IMC UAM installation.
Usually, the default port 8080 is used.
b. Leave the default settings for other parameters and click OK.
Figure 20 Portal server configuration
# Configure the IP address group.
Select User Access Manager > Portal Service Management > IP Group from the navigation tree to
enter the portal IP address group configuration page. Then, click Add configure an IP address
group as follows:
a. Enter the name Portal_user.
b. Set the start IP address to 192.168.1.1 and the end IP address to 192.168.1.255. The IP
address of Host must be within this IP address group.
c. Select the action Normal.
d. Click OK.
56