When The Switch Acts As An Stelnet Client For Password Authentication - HP 10500 Series Configuration Manual

Figure 86 Specifying the private key file
e. Click Open to connect to the server.
If the connection is successfully established, the system asks you to enter the username and
password. After entering the username (client002), you can enter the command-line interface
of the server.
When the switch acts as an Stelnet client for password
authentication
Network requirements
As shown in
B acts as the Stelnet server, adopting password authentication. The username and password of Switch A
are saved on Switch B.
Figure 87 Network diagram
Configuration procedure
1. Configure the Stelnet server:
# Generate the RSA key pairs.
<SwitchB> system-view
Figure 87, you can logs in to Switch B through the Stelnet client that runs on Switch A. Switch
224