Cannot Set The Port Security Mode; Cannot Configure Secure Mac Addresses; Cannot Change Port Security Mode When A User Is Online - HP 10500 Series Configuration Manual

Cannot set the port security mode

Symptom
Cannot set the port security mode.
[Device-GigabitEthernet1/0/1] port-security port-mode autolearn
Error:When we change port-mode, we should first change it to noRestrictions, then change
it to the other.
Analysis
For ports operating in a port security mode other than noRestrictions, you cannot change the port security
mode directly by using the port-security port-mode command.
Solution
First set the port security mode to noRestrictions.
[Device-GigabitEthernet1/0/1] undo port-security port-mode
[Device-GigabitEthernet1/0/1] port-security port-mode autolearn

Cannot configure secure MAC addresses

Symptom
Cannot configure secure MAC addresses.
[Device-GigabitEthernet1/0/1] port-security mac-address security 1-1-2 vlan 1
Error: Security MAC address configuration failed.
Error:Can not operate security MAC address for current port mode is not autoLearn!
Analysis
Secure MAC address can only be configured on ports operating in autoLearn mode.
Solution
Set the port security mode to autoLearn.
[Device-GigabitEthernet1/0/1] undo port-security port-mode
[Device-GigabitEthernet1/0/1] port-security max-mac-count 64
[Device-GigabitEthernet1/0/1] port-security port-mode autolearn
[Device-GigabitEthernet1/0/1] port-security mac-address security 1-1-2 vlan 1

Cannot change port security mode when a user is online

Symptom
Port security mode cannot be changed when an 802.1X authenticated or MAC authenticated user is
online.
[DeviceGigabitEthernet1/0/1] undo port-security port-mode
Error:Cannot configure port-security for there is 802.1X user(s) on line on port
GigabitEthernet1/0/1.
Analysis
Changing port security mode is not allowed when an 802.1X authenticated or MAC authenticated user
is online.
186