Programmable Message - GE 239 Instruction Manual

5.2.5

Programmable Message

5–62
Courtesy of NationalSwitchgear.com
• SETPOINTS GROUP CURRENTLY IN USE: Alternate setpoints (i.e.
FULL LOAD CURRENT , etc.) can be selected using the Option Switch 1 and Option
Switch 2 inputs as explained in Section 4.6: Switch Inputs on page –46. One of four
possible groups of setpoints can be selected at once. This message displays the
currently selected group.
A 40 character message can be programmed using the keypad or via the serial port using
the 239PC software. See 4.2: S1: 239 Setup on page –13 for an example of programming
this message using the keypad.
This message can be used for identification purposes such as company name, site name,
station name, relay identification number, etc. It can be chosen as the default message so
it is displayed when the unit is left alone.
CHAPTER 5: MONITORING
PHASE CT PRIMARY
239 MOTOR PROTECTION RELAY – INSTRUCTION MANUAL
,