Default Messages - GE 239 Instruction Manual

3.1.6

Default Messages

MOTOR LOAD =
70% FULL LOAD
ACTUAL VALUE OR SETPOINT TO
BE STORED AS DEFAULT MESSAGE
3–8
Courtesy of NationalSwitchgear.com
Up to 5 default messages can be selected to automatically scan sequentially when the 239
is left unattended. If no keys are pressed for the default message time set with
SETUP\PREFERENCES\DEFAULT MESSAGE TIME,
automatically be overwritten by the first default message. After 5 seconds, the next default
message in the sequence will display if more than one is selected. Trip, Alarm and flash
messages will override the default message display. Any setpoint or measured value can
be selected as a default message.
Messages are displayed in the order they are selected.
• ADDING NEW DEFAULT MESSAGE: use the
any setpoint or actual value message to be added to the default message queue and
follow the steps shown below. When selecting a setpoint message for display as a
default, do not modify the value using the
recognize the
STORE
message
STORE
STORE
TO ADD THIS DEFAULT
MESSAGE PRESS STORE
DISPLAYED FOR 3 SECONDS WHEN
STORE KEY PRESSED TWICE
If 5 default messages are already selected the first message is erased and the new
message is added to the end of the queue.
• DELETING A DEFAULT MESSAGE: Use the
default message to be erased. If default messages are not known, wait until the 239
starts to display them and then write them down. If no default messages have been
programmed, the 239 will remain on the current message and the display will dim to
the level assigned in setpoint
BRIGHTNESS after the delay assigned in
MESSAGE TIME has expired. Use the
setpoint or actual value message to be deleted from the default message queue and
follow the steps shown below.
then the currently displayed message will
MESSAGE
VALUE /
key as storing a setpoint instead of selecting a default
STORE
/
MESSAGE
S1: 239 SETUP\PREFERENCES\DEFAULT MESSAGE
S1: 239 SETUP\PREFERENCES\DEFAULT
/
MESSAGE MESSAGE
239 MOTOR PROTECTION RELAY – INSTRUCTION MANUAL
CHAPTER 3: OPERATION
S1:239
/ keys to display
MESSAGE
VALUE keys or the 239 will
NEW DEFAULT MESSAGE
SELECTED
DISPLAYED FOR 3 SECONDS WHEN
STORE KEY PRESSED
ADEFMSG.VSD
keys to display the
MESSAGE
keys to display the