GE 239 Instruction Manual page 45

CHAPTER 3: OPERATION
MOTOR LOAD =
70% FULL LOAD
ACTUAL VALUE OR SETPOINT TO
BE REMOVED FROM THE DEFAULT
MESSAGE QUEUE
239 MOTOR PROTECTION RELAY – INSTRUCTION MANUAL
Courtesy of NationalSwitchgear.com
STORE
VALID DEFAULT
RESET
MESSAGE
MESSAGE PRESS STORE
DISPLAYED FOR 3 SECONDS WHEN
STORE KEY AND RESET KEY ARE
PRESSED IN SEQENCE
NOT A DEFAULT
MESSAGE
DEFAULT MESSAGE
DISPLAYED FOR 3 SECONDS WHEN
STORE KEY AND RESET KEY ARE
PRESSED IN SEQENCE
Each 239 is pre-programmed with five default messages as shown below. Note, each time
the factory setpoints are reloaded the user programmed default messages are overwritten
with these messages.
The 239 will scroll through the default messages in the sequence shown.
SYSTEM STATUS
NORMAL
A= 100 B= 100
C= 100 AMPS
CURRENT UNBALANCE
U/B = 0 %
THERMAL CAPACITY
USED = 0 %
PHONE: 905-294-6222
GEindustrial.com/pm
FIGURE 3–6: Default Message Sequence
STORE
TO DELETE THIS
NOT A SELECTED
Location: ACTUAL VALUES A1 STATUS\GENERAL
Location: ACTUAL VALUES A2 METERING\CURRENT
Location: ACTUAL VALUES A2 METERING\CURRENT
Location: ACTUAL VALUES A2 METERING\MOTOR CAPACITY
Location: ACTUAL VALUES A1 STATUS\PROGRAMMABLE MESSAGE
DEFAULT MESSAGE
REMOVED
DISPLAYED FOR 3 SECONDS
WHEN STORE KEY PRESSED
REDEFMSG.VSD
3–9