Tilt Cylinder And Trim Cylinder; Disassembling The Tilt Cylinder And Trim Cylinder - Yamaha E115A Service Manual

Disassembling the tilt cylinder and
trim cylinder
1. Hold the PTT body in a vise using alu-
minum plates on the both sides.
2. Loosen the tilt cylinder end screw 1, and
then remove the tilt piston assembly.
cC
Make sure that the ram are fully extended
before removing the end screw.
Trim and tilt wrench 2:
90890-06587
3. Drain the fluid.
4. Loosen the trim cylinder end screws 3,
and then remove the trim piston assem-
blies.
2
3
Trim and tilt wrench 2:
90890-06587
61U5H11
5. Drain the fluid.
6. Install the trim piston assemblies, and
7. Cover the tilt cylinder opening with a
2
1
6G470510
w
Never look into the tilt cylinder opening
while removing the free piston because
the free piston and PTT fluid can be force-
fully expelled out.
8. Loosen the trim cylinder end screws, and
6G470520

Tilt cylinder and trim cylinder

then temporarily tighten the trim cylinder
end screws.
clean cloth 4, and then blow com-
pressed air through the hole a to remove
the free piston 5.
then remove the trim piston assemblies.
1
2
3
4
5
6
7
8
9
7-50