BRKT
5. Remove the circlip, and then remove
drive shaft bushing.
o
i
Bearing puller assembly i:
90890-06535
Stopper guide stand o:
90890-06538
Stopper guide plate p:
90890-06501
Checking the upper case
1. Check the rubber dampers. Replace if
deteriorated or cracked.
2. Check the cooling water pipe. Replace if
deformated or corrosion.
3. Check the exhaust guide, exhaust mani-
fold, and muffler. Replace if deformated
or corrosion.
Assembling the upper case
1. Install the drive shaft bushing into the
upper case, and then install the circlip.
NOTE:
After installing the drive shaft bushing, apply
grease to the inside of the bushing.
Needle bearing attachment 1:
90890-06653
Driver rod L3 2: 90890-06652
7-13
Bracket unit
p
o
61U70220
2
1
61U70230
2. Install a new gasket 3, the lower exhaust
guide 4, and bolts 5, and then tighten
the bolts to the specified torque.
5
4
Exhaust guide bolt 5:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
3. Install a new gasket 6, the exhaust man-
ifold 7, and bolts 8, and then tighten the
bolts to the specified torque.
8
Exhaust manifold bolt 8:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
5
3
61U70070
7
8
6
61U70080
61U5H11