Assembling The Clamp Bracket (Mh, Wh, E) - Yamaha E115A Service Manual

6. Install the lever y to the swivel bracket
4 with the cotter pin u.
7. Install the lever i to the lever y with the
2 cotter pins o.
8. Install the 2 large springs p.
9. Install the small spring a.
p
o
i
NOTE:
After assembling the swivel bracket, check
the tilt stop lever for proper operation.
Assembling the clamp bracket
(MH, WH, E)
1. Pass the through tube 1 into the clamp
bracket 2 and washer 3.
3
2
2. Install the swivel bracket 4 to the clamp
bracket 2.
3. Install the washer 5 and starboard
clamp bracket 6.
61U5H11
4
a
y
p
u
o
61U70560
1
61U70500
Clamp bracket and swivel bracket
4
2
4. Tighten the self-locking nut 7 in tempo-
rary tight.
5. Install the shock absorber 8 into the
swivel bracket 4.
6. Install the pin 9 with the circlip 0.
0
4
8
7. Tighten the self-locking nut 7 in the
specified torque.
Self-locking nut 7:
15 N·m (1.5 kgf·m, 11.1 ft·lb)
8. Install the clamp bracket bolt q, anode
w and tilt pin e.
q
e
9. Install the ground lead and caps.
5
1
2
6
61U70510
3
4
5
9
7
6
61U70520
7
8
9
w
61U070530
7-26