Checking The Hydraulic Pressure - Yamaha E115A Service Manual

BRKT

Checking the hydraulic pressure

1. Fully extend the trim and tilt rams.
2. Remove the reservoir cap, and then
check the fluid level in the reservoir.
NOTE:
If the fluid is at the correct level, the fluid
should overflow out of the filler hole when the
reservoir cap is removed.
3. If necessary, add sufficient fluid of the
recommended type until it overflows out
of the filler hole.
Recommended PTT fluid:
ATF Dexron 2
4. Install the reservoir cap, and then tighten
it to the specified torque.
Reservoir cap:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
5. Remove the circlip 1, then remove the
manual valve 2.
6. Install the up relief fitting 3 and hydraulic
pressure gauge 4.
7-35
Bracket unit
6G470240
3
NOTE:
Quickly install the special service tools before
any fluid flows out of the hole.
Up relief fitting 3: 90890-06773
Hydraulic pressure gauge 4:
90890-06776
7. Connect the PTT motor leads to the bat-
tery terminals to fully retract the trim and
tilt rams.
Rams PTT motor lead
Light green (Lg)
Down
Sky blue (Sb)
2
1
4
6G470250
Sb Lg
6G470260
Battery
terminal
+
-
61U5H11