Yamaha E115A Service Manual page 132

POWR
10. Install the Woodruff key and flywheel
magnet.
11. Tighten the flywheel magnet nut to the
specified torque.
cC
Apply force in the direction of the arrows
shown, to prevent the flywheel holder
from slipping off easily.
NOTE:
Apply engine oil to the flywheel magnet nut
thread before installation.
Flywheel holder: 90890-06522
Flywheel magnet nut:
186 N·m (18.6 kgf·m, 137 ft·lb)
12. Install the starter pulley.
13. Tighten the cable holder plate u and
retaining plate i.
u
14. Install the manual starter, start-in-gear
protection cable, and then adjust it. For
adjustment procedures,
"Adjusting the start-in-gear protection"
P3-4.
5-51
Power unit
i
61U50480
refer
15. Connect the negative battery cable o,
positive battery cable p, and PTT motor
lead a.
å
o
p
∫
a
å WH
∫ E, ET
Starter motor positive terminal nut:
9 N·m (0.9 kgf·m, 6.6 ft·lb)
16. Install the all removed parts.
to
o
61U50355
p
61U50365
61U5H11