Installing The Clamp Bracket (Et) - Yamaha E115A Service Manual

BRKT
5
3
1
2
8
0
4
q
3. Remove the trim sensor cam screw 4.
4. Remove the self-locking nut 5 and bolt
6.
5. Remove the through tube 7, then disas-
semble the clamp brackets 8 and then
remove the swivel bracket 9.
6. Remove the trim sensor 0.
7. Remove the pins q and tilt stop levers
w.

Installing the clamp bracket (ET)

1. Install the tilt stop levers onto the swivel
bracket assembly.
2. Install the trim sensor 1 and bushings 2
onto the swivel bracket assembly.
2
7-31
Bracket unit
9
w
8
6
7
61U70360
2
1
6G470760
3. Assemble the clamp brackets, washers,
swivel bracket, trim sensor, and then
install the through tube.
a
NOTE:
9 Align the projection inside of the trim sensor
cam with the through tube hole a, and then
install it.
9 Adjust the trim sensor cam after installing
the PTT.
4. Install the bolts on the through tube.
5. Install the ground lead between the
clamp brackets and the swivel bracket.
6G470765
61U5H11