Assembling The Propeller Shaft Housing - Yamaha E115A Service Manual

2. Install the dog clutch 5 onto the propeller
shaft 6.
NOTE:
Face the marking side to original direction,
and then install the dog clutch 5.
6
5
3. Insert the smallest balls 7 into the shift
slider 4, and then insert the shift slider
into the propeller shaft 6.
4. Insert the medium balls 8 into the shift
slider, and then continue to insert the shift
slider into the propeller shaft.
7
8
4
8
5. Hook the shift rod joint 9 onto the knob
on the end of the shift slider.
9
61U5H11
61U60170
6
7
61U60180
61U60190
Propeller shaft housing
6. The hole in the dog clutch align with the
2 holes (propeller shaft and shift slider).
7. Install the cross pin 0 and spring q.
q
0
Assembling the propeller shaft
housing
1. Install the new needle bearing into the
propeller shaft housing to the specified
depth.
1
3
b
NOTE:
9 Install the needle bearing with the manufac-
ture identification mark a facing toward the
propeller side.
9 Be careful not to let the stopper c get out
of position when using the driver rod SS 1.
Driver rod SS 1: 90890-06604
Needle bearing attachment 2:
90890-06610
Bearing depth plate 3:
90890-06603
Depth b:
24.75–25.25 mm (0.974–0.994 in)
1
2
3
61U60160
4
c
5
a
b
2
6
61U60070
7
8
9
6-10