Siemens SINUMERIK 810D Configuration Manual page 8

Planning Guide SINUMERIK 810D
Preface
Danger notices
The following notices are intended firstly for your personal safety and secondly
to prevent damage occurring to the products described or any connected
devices and machines.
Warning
!
When operating electrical devices, it is impossible to avoid applying hazardous
voltages to certain parts of the equipment.
After all power has been cut off, there will still be dangerous voltages present in
the intermediate circuit of all SIMODRIVE modules for a further 5 minutes!
See operating instructions.
Unqualified operator action of the device/system or failure to observe the war-
ning notices may result in serious physical injury or material damage. Only
suitably qualified personnel trained in assembling, installing, activating or
operating the product, should operate this device/system.
Additional notices
Should measurements or tests need to be carried out on the active device, it is
important to comply with the definitions and implementation instructions of acci-
dent prevention regulation VBG 4.0, in particular § 8 "Permissible differences
when working on active components". Suitable electric tools should be used.
Danger
!
This warning notice indicates that death, serious physical injury or considerable
material damage will occur if the relevant safety precautions are not taken.
Warning
!
This warning notice indicates that death, serious physical injury or considerable
material damage may occur if the relevant safety precautions are not taken.
Caution
!
This warning notice (with warning triangle) indicates that slight physical injury or
some material damage may occur if the relevant safety precautions are not
taken.
Caution
This warning notice (without a warning triangle) indicates that some material
damage may occur if the relevant safety precautions are not taken.
vi
SINUMERIK 810D Manual Hardware Configuration (PHC) - - 11.02 Edition
E Siemens AG, 2002. All rights reserved
12.95