Figure 4.14 Designating The Programming Mode And The Jedec File Path - Samsung OFFICESERV 7100 Service Manual

5) To set the programming mode, click [ ] under [JTAG Operation] on the following
window. Read the following descriptions and set the corresponding mode.

Figure 4.14 Designating the Programming Mode and the JEDEC File Path

P=Erase, Program & Verify Device W/JEDEC File
V=Verify Device against JEDEC File
R=Read checksum
N=Put Part into BYPASS mode
Select [P] to perform programming. When to program a specific CPLD among many
CPLDs connected via the chain at the Daisy Chain mode, select [N] instead of [P] for
the corresponding CPLD.
6) Designate the path where the JEDEC file of the CPLD to be programmed in the
[JEDEC File for the part] item. Click the [Browse] button on the previous window and
designate the folder. When all the configuration settings are completed for programming,
click the [OK] button.
To program the CPLD of the MP10/11 board
- Function Description: Take notes of words which indicate features of the task.
- [Select Part]
- JTAG Operation: P
- [Browse]
- [File]
directory.
- Extension: Default: '*.WCH'
© SAMSUNG Electronics Co., Ltd.
[#1 DEVICE: ispM4A]
[Package: 100P TQFP] [OK]
Erase, Program & Verify Device w/JEDEC file
Select the directory which includes the [*.JED] file.
[Save As...] Designate the name of the file and save it in the corresponding
OfficeServ 7100 Service Manual
[#2 DEVICE: M4A5-128/56-10VC]
[OK]
4-13