Samsung OFFICESERV 7100 Service Manual page 183

1) x: Board type
In case of the MP10/11 board: 0
In case of the MGI board: 1
2) y: Slot number
Slot number: 0~4(In case of MP10/11, 0 is used.)
Result display
−
x...x: This indicates the 12 digits of the MAC address of the designated board.
− FAIL or BUSY: The port which supports LAN does not exist or does not operate
normally in the corresponding port.
MACWxy n...n (6 digits)
Test item: This command enables to enter the MAC address in the MGI board or the
MP10/11 board.
When executing this command, the MGI board to be tested should be mounted on the
one-stage cabinet before testing. 'xy' is the information on the location where the
boards which require the MAC address information are mounted.
1) x: Board type
In case of the MP10/11 board: 0
In case of the MGI board: 1
2) y: Slot number
Slot number: 0~4(In case of MP10/11, 0 is used.)
3) n...n: Final 6 digits of the MAC address
'0000F0' is basically entered as the first six digits of the MAC address.
Result display
− PASS: The MAC address of the designated board is normally entered.
− FAIL or BUSY: The port which supports LAN does not exist in the corresponding
port or the MAC is not entered normally.
MPTOx
Test item: This checks if the CODEC conversion function of the MGI board operates
normally.
When executing this command, the MGI board to be tested should be mounted on the
one-stage cabinet before testing. 'x' is the slot number(0~4).
Result display
− PASS: The CODEC of the designated board operates normally.
− FAIL: The CODEC of the designated board operates abnormally.
© SAMSUNG Electronics Co., Ltd.
OfficeServ 7100 Service Manual
4-27