ABB i-bus KNX Product Manual page 25

 ®
i-bus KNX
This is an important step and it has to be performed every time a device (or devices)
is (are) added or erased.
3 Download
information on the gateway and the ETS should be synchronized. The text below the
button will indicate if the system is synchronized or not.
In case it is not, please proceed to download parameters pressing the button. When
doing so, the plugin will warn the user about the procedure, so previous configuration
will be erased.
When downloading parameters you have the option to carry out a full download or a
partial download. When check box is not enabled, a partial download is carried out
(just downloading the modifications with respect the previous integration
configuration). On the other hand, when the Full Download checkbox is enabled it
downloads the complete integration configuration and parameters.
Download process lasts some seconds and when finished the added devices will be
shown in the LCD of the KNX/EnOcean Gateway device display (press the up/down
buttons of the gateway to see them).
4
Device table: In this table all devices integrated in the project will appear letting the
user learn or erase Chip ID information from them. Basically, information shown is:
 Device Node Name: Provides information about the name of the node where
the device is setup.
 chipID_1-2-3-4-5: Provides information about the Chip ID of the integrated (or
simulated) EnOcean devices in each node. Up to 5 different devices can be
added in a single node.
 Learn: When pressing this arrow, a countdown time starts in which you can
press the teach-inbutton from your EnOcean device (the one that you want to
integrate) so the gateway can learn the Chip ID.
ABB STOTZ-KONTAKT GmbH
Eppelheimer Straße 82, 69123 Heidelberg, Germany
 +49 (0) 6221 701 607
EG/A 32.2.1
parameters: Before
Figure 5.18 Parameters not synchronized message
Figure 5.19 Warning message regarding overwriting previous configuration
 +49 (0) 6221 701 724
starting Uploading/Downloading
www.abb.com/knx
Technische Helpline / Technical Support
 +49 (0) 6221 701 434 E-Mail: knx.helpline@de.abb.com
User's manual r1.5 eng
Chip IDs,
24 / 47