Light Actuator Integration - Simulated Enocean Device (Rps) - ABB i-bus KNX Product Manual

®

i-bus KNX
d. Press the Download chip IDs button to download the chip ID information into
the KNX/EnOcean Gateway.
5. Close the plugin (all changes will be saved).
6. Use ETS to setup proper KNX group addresses for each communication object and also
a proper KNX physical address for KNX/EnOcean Gateway.
7. Download current KNX configuration to the gateway as with any other KNX product.
8. EnOcean AC interface and the KNX/EnOcean Gateway are linked and ready to be used.
Figure 3.2 KNX/EnOcean Gateway and light actuator integration example
Below there is an example on how to integrate an EnOcean light actuator controlled into KNX
through our gateway.
1. Connect KNX/EnOcean Gateway to the KNX bus and check EnOcean devices location.
2. Open the KNX/EnOcean Gateway plugin in the ETS and click on the Add Device Node
button.
a. Select the second option to simulate an EnOcean device.
b. Select "Rocker Switch & Key Card" in the family device list.
c. Select the "2-button Rocker – Light and Blind Control".
d. Click on Add Device Node button (the window will be closed).
3. Select the communication objects to be used in the node tree and other parameters in
the Gateway mapping tab. This step can be omitted if working with the default objects
and parameters.
4. Move to the Remote EnOcean Teach-in/Learning tab.
a. Click on the Download Parameters button (a message window will pop-up
indicating process progress).
b. Push the arrow in the Learn column (a pop-up window will appear).
ABB STOTZ-KONTAKT GmbH
Eppelheimer Straße 82, 69123 Heidelberg, Germany
 +49 (0) 6221 701 607
 +49 (0) 6221 701 724
EG/A 32.2.1
KNX/EnOcean Gateway
www.abb.com/knx
Technische Helpline / Technical Support
 +49 (0) 6221 701 434 E-Mail: knx.helpline@de.abb.com
User's manual r1.5 eng
8 / 47