Monitor Mode; Programming Knx Physical Address - ABB i-bus KNX Product Manual

 ®
i-bus KNX
If pressing the Learn/Teach-in button long (more than 2 seconds) the gateway will enter in
Monitor Mode. In this mode is possible to check the signal quality from each EnOcean device
linked.
To do so, simply enter to this mode, and press the Learn/Teach-in button from the EnOcean
device you want to check. A value in % will appear in the LCD indicating the signal strength.
Also the node and device number will be shown.
An extra function that is also available for visualization information improvement is the contrast
function. This function can be activated by pushing UP and Down buttons simultaneously for
more than 2 seconds. After that, by pressing the Up and Down buttons you will be able to
increase or decrease the display contrast.
In order to configure the gateway's physical address on the KNX side, you need to use the ETS
and the KNX Prog button. To do it so, go to the ETS download section (see
Depending on the changes you have done, the ETS will ask you to press the programming
button (see
Figure 6.4
After that, configuration process will start. Once download is finish, the gateway LED will turn off
automatically.
ABB STOTZ-KONTAKT GmbH
Eppelheimer Straße 82, 69123 Heidelberg, Germany
 +49 (0) 6221 701 607
EG/A 32.2.1
Figure 6.3 Download section on ETS
). Push the KNX Prog button once (internal LED will turn on in red color).
Figure 6.4 Press KNX Prog button message
 +49 (0) 6221 701 724
www.abb.com/knx
Technische Helpline / Technical Support
 +49 (0) 6221 701 434 E-Mail: knx.helpline@de.abb.com
User's manual r1.5 eng
).
Figure 6.3
28 / 47