Device Programming And Monitoring Buttons; Learn/Teach-In Enocean Devices - ABB i-bus KNX Product Manual

 ®
i-bus KNX

6 Device programming and monitoring buttons

The KNX/EnOcean Gateway includes programming buttons in case you want to program or
monitor devices without the help of our ETS plugin. We recommend to use the plugin for the
programming of the gateway. The following and in chapter 10 shown possabilities are only an
addiational feature.
In Figure 6.1 you can see the available buttons and below you can find an explanation about
them.
NOTE: It is not possible to add new device nodes with the programming buttons. You
must to use the ETS plugin for this.
1
KNX Prog Button: Button used to program the KNX physical address into the gateway.
2
Erase Button: Button used to erase linked EnOcean devices and nodes.
3
Learn/Teach button: Button used to link and monitor EnOcean devices.
4
Up arrow button: Browse configured device list in an ascending way.
5
Down arrow button: Browse configured device list in a descending way.
More information about programming buttons and all functionalities available can be found in
section 10.
When learning EnOcean devices are linked with the gateway, Teach button from our gateway
has to be pressed and an "L" appears on the right side of the LCD display. Then the gateway
will be in "Learn" mode. In order to link an EnOcean device with the device appearing in the
LCD display, click on the Learn/Teach-in button from the EnOcean device and it will be linked. It
ABB STOTZ-KONTAKT GmbH
Eppelheimer Straße 82, 69123 Heidelberg, Germany
 +49 (0) 6221 701 607
EG/A 32.2.1
1
2
3
4
Figure 6.1 KNX/EnOcean Gateway interior view
 +49 (0) 6221 701 724
Figure 5.22 Erasing process
www.abb.com/knx
Technische Helpline / Technical Support
 +49 (0) 6221 701 434 E-Mail: knx.helpline@de.abb.com
User's manual r1.5 eng
5
26 / 47