Plc Side Settings - Mitsubishi Electric GOT1000 Series Connection Manual

POINT POINT POINT
(1) Delay Time
When connecting to PLC CP-9200(H) and CP-
9300MS, set the following.
Model name
CP-9200(H)
port:0
CP-9300MS
port:1
(2) Communication interface setting by the Utility
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
GT User's Manual
(3) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
6.2.9
POINT POINT POINT
Delay Time
30ms or more
10ms or more
30ms or more

Communication and port settings
Make the communication and port settings with a
peripheral tool.
Device name
Address
Protocol
Mode
Transmission
speed
Data bit
Stop bit
Parity bit
Error check
6. CONNECTION TO YASKAWA PLC

PLC Side Settings

YASKAWA PLC
For details of YASKAWA PLCs, refer to the following
manuals.
YASKAWA PLC user's Manual
*1
4800bps, 9600bps, 19200bps, 38400bps,
*2*3
57600bps
*1 Set the address according to the Host Address setting on the
GOT side.
For the Host Address setting on the GOT side, refer to the
following.
6.2.8 ■ Communication detail settings
*2 Only transmission speeds available on the GOT side are
shown.
Also, the setting range differs depending on the YASKAWA
PLC model.
*3 The transmission speed setting must be consistent with that
of the GOT side.
For the transmission speed setting on the GOT side, refer to
the following.
6.2.8 ■ Communication detail settings
6.2 Serial Connection
Set value
1 to 31
MEMOBUS
RTU
8bits
1bit
Even
CRC16
6 - 17
1
2
3
4
5
6
7
8