ABB SM3000 User Manual page 85

...4.6.2 Analog Input Configuration
•1 If this parameter is changed, a new internal data file for this recording channel is created. All historical data stored internally for this
channel is lost.
Set the required electrical range.
Notes.
• Applicable only to mA, mV, V and Resistance input types.
• When an input is connected through an external voltage
divider (see
Warnings
and high values to the actual voltage applied to the divider,
not the voltage after it has been divided down.
The range of the electrical input signal is determined by the
input type:
Input Standard Inputs
Type
mV V
Min.
0 0
Max.
2000 20
Limits of Electrical Ranges
Specify the display range and units of the engineering value
•1
corresponding to the electrical high and low values, within
•1
the limits defined in the following table:
•1
THC/RTD Type
Type B
Type E
Type J
Type K
Type L
Type N
Type R&S
Type T
Pt100
Power 5/2
Power 3/2
Square Root
Custom Linearizer 1
Custom Linearizer 2
Custom Linearizer 3
Custom Linearizer 4
Linear
Limits of Engineering Ranges
– for an electrical input range of 4.0 to 20.0mA,
Example
representing a pressure range of 50 to 250 bar, set the
'Engineering low' value to 50.0 and the 'Engineering high'
value to 250.0.
4 CONFIGURATION...
above), set the electrical range low
High Specification Inputs

mA mV V
0 0 –1000 –50
50 5000 1000 50
C
Min. Max. Min.
–18 1800 0
–100 900 –140
–100 900 –140
–100 1300 –140
–100 900 –140
–200 1300 –325
–18 1700 0
–250 300 –400
–200 600 –325
–999 to +9999

mA
–100 0
100 2000
F
Max.
3270
1650
1650
2350
1650
2350
3090
570
1100
83