ABB SM3000 User Manual page 75

...4.5.2 Configuring the Chart View
Vertical and Horizontal Chart Views only
Circular Chart View only
OR
Select the amount of historical data to be displayed on the
screen. Available selections are limited by the sample rate
selected – see Page 70 and Table 2.1 on page 13.
Select the required trace width in pixels (Vertical and
Horizontal Chart views only).
Select the menu items to be accessible from the Chart View.
Message select enable
Enables the operator to activate one of 24 pre-configured
messages or a user-defined message.
Alarm acknowledge enable
Enables the Operator to acknowledge any alarms
associated with the current group.
Scale select enable (Vertical and Horizontal Chart views only)
Enables the operator to select which scales are displayed on
the scale bar at the top of the screen.
Trace select enable
Enables individual chart traces to be displayed or hidden.
Screen interval select enable
Enables the Operator to change the amount of data
displayed on the screen at one time.
Historical review enable
Enables the Operator to scroll back through data recorded
previously that is no longer visible on screen.
Chart annotation select enable
Enables the display of Alarm events and Operator messages
on the chart to be enabled or disabled by the operator.
Totalizer reset enable (Circular Chart view only)
Enables the Operator to reset the totalizers on any or all
channels.
Totalizer stop/go enable (Circular Chart view only)
Enables the Operator to stop and start totalizers on any or all
channels.
Note. Menu items that are not enabled are greyed-out in the
relevant Chart View menu.
4 CONFIGURATION...
73