Recording Channel Setup - ABB SM3000 User Manual

...4 CONFIGURATION

4.6.1 Recording Channel Setup

'Chart view enable' set to 'Vertical', 'Horizontal -->' or 'Horizontal <--'
'Chart view enable' set to 'Circular'
•1 If this parameter is changed from any previous setting other than 'None', a new internal data file for this recording channel is
created. All historical data stored internally for this channel is lost. If this parameter is changed from a previous setting of 'None',
new internal data files for all enabled recording channels are created. Any unarchived data is lost.
80
OR
•1
Select the signal source for the selected channel. This can be
any external analog or digital signal – see APPENDIX 1 for full
list.
Note. The tabs change according to the selection made.
Note. Setting a channel source to 'None' does
off the analog input to which the channel was assigned
previously – i.e. the analog input continues to be monitored.
To switch off an analog input, set Analog I/P 'Type' for the
required channel to 'Off' – see Section 4.6.2.
The trace color cannot be changed. The trace colors are:
st nd
1 2
Magenta Red
th th
7 8
Yellow Dark
Yellow
Each recording channel can be configured to position its
trace in a specific zone in the vertical or horizontal chart
views in order to separate traces that would otherwise be
very close to each other.
Select one of the 15 pre-defined or 10 custom zones
available. See Section 4.8.2 for custom zone configuration
details.
A – Analog Source
B – Digital Source
rd th th
3 4 5
Black Green Blue
th th th
9 10 11
Cyan Light Dark
Green Cyan
switch
not
th
6
Brown
th
12
Dark
Magenta