4.2 Mounting Bracket Options
The transceiver is normally provided with flat mounting brackets attached to the bottom of the
radio as shown in Figure 14. An optional 35 mm DIN rail mounting bracket is also available, and
is described below.
NOTE To prevent moisture from entering the radio, do not mount the case with the cable con-
nectors pointing up. Also, dress all cables to prevent moisture from running along the
cables and into the radio.
Optional DIN Rail Mounting
The unit may be mounted with an optional 35 mm DIN Rail Mounting Bracket Kit (Part No. 03-
4125A04). Equipment cabinets and racks of modern design often employ this type of mounting.
Once the DIN bracket is attached to the radio, it allows for quick installation and removal of the
radio from its mounting rail without the need for tools.
The DIN Rail bracket attaches to the unit's case as shown in Figure 15. The entire assembly then
attaches to the mounting rail.
MDS 05-4864A01, Rev. I
Figure 13. Transceiver Dimensions
Figure 14. Mounting Bracket Dimensions
SD Series Technical Manual
17