GE MDS SD Series Technical Manual page 38

pending on ordering options. If no frequencies have been set, an alarm condition is gen-
erated and the
all cases, users must verify that the frequencies are properly set according to the station
license.
NOTE Operation on exact multiples of 25 MHz is not supported by the SDx transceiver (i.e.,
400, 425, 450, 475, and 500 MHz).
NOTE The option to configure the Radio Mode is also available under
der
Device Settings
Continue through each wizard screen until all selections have been made. (You may back up to
previous screens if required, to review or change settings.) If you are unsure about a required set-
ting, contact your Network Administrator for assistance.
5. At the conclusion of the wizard, click
nected radio. Log out of the Device Manager by clicking
of the screen. If desired, you may proceed with the additional functions described below.
Using the Remote Management Wizard
To program the key settings of Remote radios installed in the wireless network, select
ards>>Remote Management from the AP or Master Radio
At the conclusion of the wizard, click
tion is now complete.
28
LED flashes. These will be cleared after the frequencies are set. In
PWR
.
Figure 25. Basic Setup Wizard
Done
Commit Configuration
SD Series Technical Manual
. Configuration is now complete for the con-
Logout
and follow the prompts contained in that tool.
, followed by
Configuration >> Radio
in the upper right hand side
Setup Wiz-
. Remote configura-
Done
MDS 05-4846A01, Rev. I
un-