GE MDS SD Series Technical Manual page 48

Task
If you wish to...
Category
Start radio network reprogramming (and
monitor progress)
Perform Ethernet PING to local Ethernet
host
Test communications to specific Remote
radio
Enter a Factory Authorization code, or
view currently enabled features
View active Alarms
View logged Events
Set alarm signal output (active high/low)
Conduct an Alarm Test
View I/O Statistics for COM1, COM2, Ethernet
Port, Remote Programming, Ethernet Interface,
Data Link Layer, and MAC.
View MAC Routes
The remainder of this section covers the screens for
the transceiver. The emphasis is on available selections, how to access them, and their effect on
radio operation. If you are unsure of the setting required for a particular radio in your network,
consult your Network Administrator for assistance.
38
Table 11. Device Manager Quick Reference
SD Series Technical Manual
Refer to this
Screen/Section
Maintenance & Status>>
Firmware Utilities>>
Remote Reprogramming,
Page 78
Maintenance & Status>>
Radio Test>>Ping Test,
Page 75
Maintenance & Status>>
Radio Test>>Link Test,
Page 74
Maintenance & Status>>
Firmware Utilities>>
Authorization Codes, Page
80
Maintenance & Status>>
Alarm Summary, Page 69
Maintenance & Status>>
Event Log, Page 69
Maintenance & Status>>
Alarm Summary>>
Alarm Signal
Configuration, 70
Maintenance & Status>>
Radio Test>>
Alarm Test, 76
Maintenance & Status>>
Performance>>
I/O Statistics, Page 72, and
Ethernet Statistics, Page
72
Maintenance & Status>>
Performance>>
MAC Routes, Page 73
, and
Configuration Maintenance and Status
of
MDS 05-4846A01, Rev. I