Figure 23. PC Connection to Radio for Web Management
Logging On
1. Connect the radio to a PC via an Ethernet connection.
2. Configure your PC network settings to an IP address on the same subnet as the radio. The
default subnet mask is
3. Enter the radio's IP address in a web browser window, just as you would enter a website
address (http://192.168.1.1). When the login screen appears (Figure 24), enter the User
Name and Password for the radio. The default entries for a new radio are both
.
OK
Using the Basic Setup Wizard
4. The Basic Setup Wizard (Figure 25) begins automatically upon connection to a new factory
shipped radio. It may also be started manually by selecting
then clicking
Start
•
TX/RX Frequencies
•
System ID
•
RF Output Power
•
Radio Mode
•
Modem Type (Transparent or Packet w/MAC)
•
Com 2 Port Baud Rate
•
Bridge Mode
•
Encryption Mode
•
DLINK Passphrase
•
Device Type
•
Ethernet Settings
NOTE TX and RX frequencies may not be set when the radio is shipped from the factory, de-
MDS 05-4864A01, Rev. I
.
255.255.0.0
Figure 24. Login Screen
. The Wizard displays a series of screens with key selections as follows:
SD Series Technical Manual
admin
Setup Wizards>>Basic Setup
. Click
, and
27