•
Current Default Gateway
grammed.
•
Static IP Address
and serial device (terminal server) services. An IPv4 IP address should be entered in this
field, unless DHCP is enabled, in which case it is not required.
•
Static IP Netmask
used when the radio attempts to send a locally-initiated message, either from the terminal
server, or a management process. You do not need to define it if DHCP is enabled.
•
Static Default Gateway
router connected to the radio.
•
— Dynamic Host Configuration Protocol (DHCP) handles the assignment of IP pa-
DHCP
rameters (Address, Netmask, Gateway) to all units in a network, and allows for introduc-
ing new devices on the network with minimal manual intervention. The assigned parame-
ters are valid for a specific "lease" time, at which point they can be reassigned or re-
newed.
IP2 Configuration
When VLAN mode is set to anything other than
the
should be specified in the
Data VLAN
•
Current IP Address
•
Current Subnet Mask
•
Current Default Gateway
grammed.
•
Static IP Address
and serial device (terminal server) services. An IPv4 IP address should be entered in this
field, unless DHCP is enabled, in which case it is not required.
•
Static IP Netmask
used when the radio attempts to send a locally-initiated message, either from the terminal
server, or a management process. You do not need to define it if DHCP is enabled.
•
Static Default Gateway
router connected to the radio.
•
— Dynamic Host Configuration Protocol (DHCP) handles the assignment of IP pa-
DHCP
rameters (Address, Netmask, Gateway) to all units in a network, and allows for introduc-
MDS 05-4864A01, Rev. I
— Read-only indication of the current default gateway pro-
— The radio requires a local IP address to support remote management
— This refers to the radio's IPv4 local subnet mask. This parameter is
— This is the IPv4 address of the default gateway device, typically a
IP2 Configuration
— Read-only indication of the current IP address programmed.
— Read-only indication of the subnet mask programmed.
— Read-only indication of the current default gateway pro-
— The radio requires a local IP address to support remote management
— This refers to the radio's IPv4 local subnet mask. This parameter is
— This is the IPv4 address of the default gateway device, typically a
SD Series Technical Manual
, the IP address of the radio as seen by
Disabled
menu.
65